A reservoir-type oxygen sensor with 2×3 array for measuring cellular respiration levels

Jungil Park, Hyunwook Nam, Sun Young Ahn, Youngmi Kim Pak, James Jungho Pak

Research output: Contribution to journalArticle

11 Citations (Scopus)

Abstract

This paper describes a 2 × 3 reservoir-type oxygen sensor array integrated with Clark-type sensors, heaters, and temperature sensors on a glass substrate. The measured 90% response time of the fabricated sensors from an air-saturated state to a zero-oxygen state was approximately 9.35 s. These oxygen sensors showed good repeatability during 6 consecutive measurements at 300-s intervals, with an output of 108.2 ± 3.15 nA (mean ± standard deviation) for the air-saturated state and 1.33 ± 0.14 nA for the zerooxygen state. In addition, these sensors showed good linearity, with a correlation coefficient of 0.995 and a sensitivity averaging 2.04 A/cm2 M. A LabVIEW-based measurement system was developed for simultaneously measuring the multiple cellular respiration levels from this oxygen sensor array using a voltage supply, an amplifying module, a DMM (digital multimeter), a switch module, and a temperature-sensing module. The measured cellular respiration ratio of the L6 (rat skeletal muscle cells) between the uncoupled oxygen consumption rate and the coupled oxygen consumption rate for this oxygen sensor array was 2.06, which is similar to the 2.23 value obtained from a commercially available system.

Original languageEnglish
Pages (from-to)913-920
Number of pages8
JournalSensors and Actuators, B: Chemical
Volume176
DOIs
Publication statusPublished - 2013 Apr 2

    Fingerprint

Keywords

  • Array type
  • Cellular respiration
  • Electrochemistry
  • Oxygen consumption rate
  • Oxygen sensor

ASJC Scopus subject areas

  • Instrumentation
  • Materials Chemistry
  • Surfaces, Coatings and Films
  • Metals and Alloys
  • Electronic, Optical and Magnetic Materials
  • Condensed Matter Physics
  • Electrical and Electronic Engineering

Cite this