Inspection of PN, CO2, and regulated gaseous emissions characteristics from a GDI vehicle under various real-world vehicle test modes

Kangjin Kim, Wonyong Chung, Myungsoo Kim, Charyung Kim, Cha Lee Myung, Simsoo Park

Research output: Contribution to journalArticle

Abstract

Although the chassis dynamometer type approval test considers real-world conditions, there are a few limitations to the experimental test environment that may affect gaseous or particulate emissions such as road conditions, traffic, decreasing tire pressure, or fluctuating ambient temperature. Furthermore, the real driving emission (RDE) test takes a long time, and it is too long to repeat under different experimental conditions. The National Institute of Environmental Research (NIER) test modes that reflect the driving pattern of Korea are not certification test modes, but can be used to evaluate the influence of traffic conditions because these modes consist of a total of 15 test modes that vary according to average speed. The use of the NIER #03, #09, and #13 modes as low-, medium-, and high-speed modes allow for gaseous and particulate emissions to be measured and analyzed. Additionally, the worldwide harmonized light-duty vehicle test procedure (WLTP), the certification mode of Europe, is used to test cycles to investigate the difference under cold- and hot-engine start conditions. The engine operating parameters are also measured to evaluate the relationships between the various test conditions and test cycles. The regulated and greenhouse gas levels decrease under various driving conditions, but the particle number (PN) emission level shows a different trend with gaseous emissions. While the PN and CO2 results dramatically increase when the air conditioner is on, tire pressure conditions show different PN size distributions: a large-sized PN fraction, which contains particles larger than 100 nm, increases and a sub-23 nm-sized PN fraction decreases. Under cold-start conditions in the WLTP modes, there are much higher PN emissions than that of an engine under hot-start conditions, and the sub-23-nm-sized PN fraction also increases.

Original languageEnglish
Article number2581
JournalEnergies
Volume13
Issue number10
DOIs
Publication statusPublished - 2020 May

Keywords

  • Carbon dioxide (CO)
  • Driving conditions
  • EEPS
  • GDI
  • NIER testing mode
  • Particle number (PN)

ASJC Scopus subject areas

  • Renewable Energy, Sustainability and the Environment
  • Energy Engineering and Power Technology
  • Energy (miscellaneous)
  • Control and Optimization
  • Electrical and Electronic Engineering

Fingerprint Dive into the research topics of 'Inspection of PN, CO<sub>2</sub>, and regulated gaseous emissions characteristics from a GDI vehicle under various real-world vehicle test modes'. Together they form a unique fingerprint.

  • Cite this