Surface tension measurements of 430 stainless steel

Joongkil Choe, Han Gyeol Kim, Youngjin Jeon, Hyeok Jun Park, Youngjo Kang, Shumpei Ozawa, Joonho Lee

Research output: Contribution to journalArticle

7 Citations (Scopus)

Abstract

The surface tension of 430 stainless steel was measured using an electromagnetic levitation (EML) method at temperatures of 1707-2000 K, under a 5 vol% H2-He atmosphere. For comparison, the surface tension was also measured using a constrained drop method; specifically the advanced sessile drop method. At 1823 K, the surface tension of the 430 stainless steel was estimated from the electromagnetic levitation and the constrained drop methods to be 1.802 and 1.614 N/m, respectively. A subsequent analysis of oxygen content showed that the former contained ∼7 ppm oxygen, whereas the latter had 60 ppm. It was therefore considered that the observed difference in measurements was the result of a contamination by oxygen. Furthermore, the EML experimental results were found to be close to the theoretically calculated values for the Fe-Cr-Si system. Consequently, for complex multi-component commercial steels such as the 430 stainless steel, the levitation method is recommended for the measurement of surface tension.

Original languageEnglish
Pages (from-to)2104-2108
Number of pages5
JournalISIJ International
Volume54
Issue number9
DOIs
Publication statusPublished - 2014 Jan 1

    Fingerprint

ASJC Scopus subject areas

  • Mechanical Engineering
  • Mechanics of Materials
  • Materials Chemistry
  • Metals and Alloys

Cite this

Choe, J., Kim, H. G., Jeon, Y., Park, H. J., Kang, Y., Ozawa, S., & Lee, J. (2014). Surface tension measurements of 430 stainless steel. ISIJ International, 54(9), 2104-2108. https://doi.org/10.2355/isijinternational.54.2104